Gents , I'm running a stock 350/400 set up in a 37 Chev truck. Only mods is an rv cam. For a daily driver what Torque converter should I use?...
working on a 30 model sedan,i have a turbo 400 tranny ,i have a ford 9 ". the tranny has a tailstock that has a yoke inserted about 2 1/2 inches and...
Contempalting a 4 link for the rear of the fargo, since I went to all the work to do the crown vic frt end. Figure I might as well go balls deep. ...
i have read on another site,trans 3 degrees down,rear end 3 degrees up.how does this sound?how much clearance do we need for suspension...
Hey All A nice day to work outside so i took the rearend out of the old 68 t-bird.As you can see it's kind of a strange set up.Not sure what they...
Over the past few years, I know a few of you have sent me contacts for guys you think might be able to fix my 54 Powerglide if/when my ability dries...
Ok one for the 'technically inclined' amongst us. My new repop Lincoln rear brake drums bind on the outside edge of the brake shoes so the...
What years old Fords have a tube driveshaft inside the torque tube? My local machinist quoted me an outrageous price to respline a solid one to...
Anybody got a stock A rear and driveshaft? I need to find the length of the driveshaft and tube, from the flange to the ball end. I'm gonna shorten...
I made one of these for a member here last year. I also have one in my own car, and done a few for some race guys. ...
I got a T5 transmission (5 speed) from a V6 Camaro and it has a counter weight on the tail stock. Anyone know why it's there?
I need some ideas and help. Switching the PG bellhousings (the "new" 54 is getting the "old" 53 bellhousing) and I cannot get the 53's bellhousing...
What am I missing? I started to tear down the rear diff tonight with my son on the impact gun. we pealed the brakes off, removed the yolk, popped...
So you scored an 8 inch Ford rear end for your project but all the brake guts are missing ? Its happened to me on a few occasions. You'd think you...
While we were pulling the engine todat on the 67 t-bird i had a crawl underneath and snapped a few pics.I'm not sure what to call this a 3 link,a 4...
I managed to pull the old powerglide and get it very near the floor before it rolled off onto the cushioning tire I placed to the sides - figured I'd...
I need to increase the back spacing on my Ford 9" rear axles by 3/4". I'm using Lincoln styled drums and early Ford backing plates. The problem is...
LOL....ok jokes aside, well i need a rearend for my Roadster, i measured the stock A Banjo and it was 50", my 8"in my T measures 49". I got a Camaro...
I got a Cast iron powerglide in my 54 pontiac and the vacuum Mdulator plate is broken and it leaks really bad , So if anybody has a Cast Iron...
working on 30 model a.i plan on using a 350,700r trans,28 to 30 " tires.(15").not too wide.would like to drive alot so should be decent on gas.low...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
